Language
 
 
Primare A34.2 Stereo Power Amplifer
 
 

Primare A34.2 Stereo Power Amplifer

The Primare A34.2 is a 2 x 150 watt stereo power amplifier utilising proprietary UFPD technology, designed to provide high power output with very low distortion for Primare's PRE32 audiophile preamplifier and all other preamps, as well as multi-channel audio processors. It uses two discrete UFPD amplifiers, each channel incorporating unbalanced (RCA) and balanced (XLR) inputs, as well as high quality gold plated speaker terminals, trigger and RS232 control inputs.

Ecologically the Primare A34.2 power amplifier is far superior to conventional Class A/B designs being extremely efficient without generating excessive heat. In standby it consumes only 0.3W. The Primare A34.2 can easily be switched to bridged mode and will then provide one fully balanced mono channel capable of delivering up to 550W into 8 ohms.

Primare's UFPD technology provides for the possibilities of a full-range 'audiophile' Class D design. It is a new and significant Class D technology which is remarkable for its performance consistency across the entire audio bandwidth. Traditional Class D amplifiers have a signature response, which is fabulous at low frequencies but can sound harsh and brittle at higher frequencies due to circuit instability produced by insufficient feedback. UFPD actively adjusts the feedback required to deliver a higher level of gain across the entire audio band, maintaining performance irrespective of load (impedance) variations. Primare's UFPD treats all signals equally, keeping distortion very low at all frequencies. With a very wide 'load independent' frequency response UFPD is able to drive any speaker while maintaining control and accuracy.

In conjunction with UFPD, Primare uses an isolated PFC (Power Factor Control) technology in the power supply, which controls the current from the mains voltage so that it is a pure sine wave with the same frequency and phase as the mains voltage. This means that even if 1000W is taken from the mains, other equipment in the room will not be affected.

  • Output power 2 x 150W @ 8 ohm
  • Bridged output power 1 x 550W @ 8 Ohm
  • Utilising proprietary UFPD technology
  • Inputs 2 x RCA / 2 x XLR switchable, RS232, trigger (12V)

Specification : 

  • Power Output
2 x 150 Watts @ 8 Ohms
  • Dimensions (HxWxD) in mm
105x430x385
  • Power Consumption
Standby: 0.3 Watts
  • Total harmonic distortion
0.005%
  • Signal to noise ratio
0.5dBV
  • Freqency Response
20Hz - 20kHz
  • Output impedance
0.3 Ohm @ 1kHz
  • Input impedance
15k Ohms
  • Inputs
2 x RCA, 2 x XLR
  • Weight

10.5Kg

 

For more information,

Please Contact ; Dicky Ng 012-3308893

Email : dickyng@cmy.com.my

 

 

 

 

 

 

 

Available Options:
Stock Availability : Available
Qty :
 

 
 
Copyright © 2016 CMY Audio & Visual. All Rights Reserved.